Gallery logo: Your photos on your web site

 

Album info

  • Title: Robs Camaro
  • Description: Oh shit, did I forget to tell you guys I used to be Camaro Dan? Well it is true. I used to be Mopar Dan before that then there was a brief stint as MG Dan. Go figure. Well all my buddies just own different cars. The DZ 302 and this car are but a few of the total done by me.
  • Owner: Gallery Administrator

Random image

IMAG2026

Robs Camaro

  • Here you have the shot of the Spring Perch Area without the Adapter or Leaf Spring in place. See the square hole in the bottom of the car for the tab? You can also see the hole on the upper frame rail and the lower one in the body.

    • Here you have the shot of the Spring Perch Area without the…
    • Views: 884
    • By: Gallery Administrator

  • You have to correctly place the jack stands in order to make the job go ok. If you have them to close to the leaf spring then you will not be able to remove the spring or the plate.

    • You have to correctly place the jack stands in order to make…
    • Views: 733
    • By: Gallery Administrator

  • This is the correct hole to hook up tie downs into. Car Haulers often times over torque the tie down chains and ruin this area.

    • This is the correct hole to hook up tie downs into. Car Hau…
    • Views: 846
    • By: Gallery Administrator

  • Here once agian is the correct orientation for the leaf spring thru bolts and the rear leaf spring shackles.

    • Here once agian is the correct orientation for the leaf spri…
    • Views: 763
    • By: Gallery Administrator

  • You will notice that the upper bolt goes threaded end away from the fule tank. The lower bolt goes threaded end towards the fuel tank.

    • You will notice that the upper bolt goes threaded end away f…
    • Views: 699
    • By: Gallery Administrator

  • Whatever you do make sure that you put a whole lot of silicone grease on these bushings. They will squeek and holler if you do not.

    • Whatever you do make sure that you put a whole lot of silico…
    • Views: 801
    • By: Gallery Administrator

  • Look at the nice finish on the leaf spring. I am looking forward to seeing the day this car has extensive miles on the clock. I really want to know how the coating holds up to a flexable leaf spring.

    • Look at the nice finish on the leaf spring. I am looking fo…
    • Views: 697
    • By: Gallery Administrator

  • Once again correct placement of the jack stand is imperative to performing the job correctly. Not to mention putting in the front bolt the right way. You will not be able to install the Perch if you put it in backwards.

    • Once again correct placement of the jack stand is imperative…
    • Views: 914
    • By: Gallery Administrator

  • Here are all the actors in this play. On the top left you have the Mono Leaf Spring, four Polyurethane Bushings, Two Shackle plates, Two Thru Bolts and nuts, Silicone Grease and the installation tool.

    • Here are all the actors in this play. On the top left you h…
    • Views: 766
    • By: Gallery Administrator