Gallery logo: Your photos on your web site

 

Album info

  • Title: Robs Camaro
  • Description: Oh shit, did I forget to tell you guys I used to be Camaro Dan? Well it is true. I used to be Mopar Dan before that then there was a brief stint as MG Dan. Go figure. Well all my buddies just own different cars. The DZ 302 and this car are but a few of the total done by me.
  • Owner: Gallery Administrator

Random image

Yessa Master

Robs Camaro

  • Here you can see the pinch weld that raises havock with the bolt installation. That is why a Piece of allthread can help install the Polys.

    • Here you can see the pinch weld that raises havock with the…
    • Views: 756
    • By: Gallery Administrator

  • Now what do you suppose caused this rip in the rear frame rail?

    • Now what do you suppose caused this rip in the rear frame ra…
    • Views: 857
    • By: Gallery Administrator

  • Kinda looks funky. I will have to think about this for a while. I bet it has been there since the factory did it.

    • Kinda looks funky. I will have to think about this for a wh…
    • Views: 711
    • By: Gallery Administrator

  • Here is another shot of the spring perch area. Make sure you do not loose these original tinneman nuts that are in the car. Replacements are impossible to find and they break imediately upon install.

    • Here is another shot of the spring perch area. Make sure yo…
    • Views: 769
    • By: Gallery Administrator

  • Notice the correct orientation of the thru bolt in the spring perch. If it goes in backwards the spring will not bolt into the body.

    • Notice the correct orientation of the thru bolt in the sprin…
    • Views: 755
    • By: Gallery Administrator

  • In other words the bolt goes threaded side to the body bolt side of the perch

    • In other words the bolt goes threaded side to the body bolt…
    • Views: 691
    • By: Gallery Administrator

  • Here you have an example of the correct placement of the Silicon Grease. Boy if you think your Old Lady whines just wait until you hear a Poly bushing with out lube.

    • Here you have an example of the correct placement of the Sil…
    • Views: 763
    • By: Gallery Administrator

  • Notice the solid metal insert. Hope you do not forget this. If you do the bolt will never tighten and the busings will hold the spring in one place only.

    • Notice the solid metal insert. Hope you do not forget this.…
    • Views: 606
    • By: Gallery Administrator

  • Here is a shot of the two spring perches all coated up and ready to install

    • Here is a shot of the two spring perches all coated up and r…
    • Views: 745
    • By: Gallery Administrator