Gallery logo: Your photos on your web site

 

Album info

  • Title: Jims 66 GTO
  • Description: No description
  • Owner: Gallery Administrator

Random image

Balancer Bolt

Jims 66 GTO

  • In this case that is not very structurally supportive. It does not make the crossmember into a structural member. It leaves the bolt heads exposed on the bottom of the frame.

    • In this case that is not very structurally supportive. It d…
    • Views: 847
    • By: Gallery Administrator

  • This type of modification makes sure that the bolts, and mount are out of the danger zone to get damaged by Speed Bumps, Rabbits, and Rice Rockets that you run over.

    • This type of modification makes sure that the bolts, and mou…
    • Views: 876
    • By: Gallery Administrator

  • The welds are a major area of importence. In this case Jim was desiring having the job done right. He was thinking about performing the job himself. That would of taken quite a bit of practice.

    • The welds are a major area of importence. In this case Jim…
    • Views: 1055
    • By: Gallery Administrator

  • The rear plates welded in perfectly. The front plates were not to kind to me. I do not know if the welder was defective, gas was contaminated, or what. The welds would be laid down perfect then all of a sudden go to hell.

    • The rear plates welded in perfectly. The front plates were…
    • Views: 874
    • By: Gallery Administrator

  • It could of been outgassing of the metal, lack of correct current regualtion, contaminated welding wire. There were many reasons why. In this case it takes a good welder to perform the job.

    • It could of been outgassing of the metal, lack of correct cu…
    • Views: 922
    • By: Gallery Administrator

  • There is no reason in the world to try this yourself. If you can say that you are a welder, then go ahead. If you screw it up, the Frame can Warp. You can pretty much screw up a good frame real easy. Not to mention create a lot of time loss with th...

    • There is no reason in the world to try this yourself. If yo…
    • Views: 808
    • By: Gallery Administrator

  • Now it is time to cut of the ears from the Tranny Mount. I do not just cut the ears off to the dimension that I need. I first cut them a little long. Then I set it on the frame and measure to make sure it is perfectly centered in the frame. Then I ...

    • Now it is time to cut of the ears from the Tranny Mount. I…
    • Views: 776
    • By: Gallery Administrator

  • The OEM mount indexes into the U Channel. This is the only way you can provide the Structural Support, Frame Rigidity, and correct attachment as required.

    • The OEM mount indexes into the U Channel. This is the only…
    • Views: 835
    • By: Gallery Administrator

  • Many people are copying my ideas. That is fine. I would rather see them do this, than to adopt other ignorant methods of attachment.

    • Many people are copying my ideas. That is fine. I would ra…
    • Views: 879
    • By: Gallery Administrator