Gallery logo: Your photos on your web site

 

Album info

  • Title: Steves 65 Tri Power
  • Description: No description
  • Owner: Gallery Administrator

Random image

To make such a work of art is very labor intensive. I therefore go out of my way to make sure that it shows up that way.

Steves 65 Tri Power

  • Here are my favorite studs. They have a nice HEX fitting on the top of them to keep the nuts from falling under the intake manifold onto the valley pan. Notice the cute looking gold coating. I change the nuts. In your case I am gonna remake an OEM ...

    • Here are my favorite studs. They have a nice HEX fitting on…
    • Views: 651
    • By: Gallery Administrator

  • These are the infamous front upper air horn carb tags. They are individually numbered and located due to postion. There are other ways to determine that the carburetors are original items but these are the easiest.

    • These are the infamous front upper air horn carb tags. They…
    • Views: 714
    • By: Gallery Administrator

  • They are installed on the Drivers side front corner screw on the front and rear carburetor. On the center carburetor they are installed on the center. Now many people will argue this but the old ones I have taken apart all had them located there.

    • They are installed on the Drivers side front corner screw on…
    • Views: 778
    • By: Gallery Administrator

  • So far so good. Notice the front fuel line. It is incorrect. The routing is wrong. The Reproduction lines are incorrectly bent and are not correct. If you want me to fab you a correct set let me know.

    • So far so good. Notice the front fuel line. It is incorrec…
    • Views: 646
    • By: Gallery Administrator

  • These pictures are shot to indicate the typical mistakes that can occur when these are incorrectly assembled. In this case I got a new guy and told him to put it together for pics. He put it together like most would.

    • These pictures are shot to indicate the typical mistakes tha…
    • Views: 645
    • By: Gallery Administrator

  • Notice that the rear carb to center carb linkage rod is installed on the outside. That is not the way they came from the factory. Many setups are assembled like this. Of course they would not of bent the back carb rod the way it was if this was corr...

    • Notice that the rear carb to center carb linkage rod is inst…
    • Views: 729
    • By: Gallery Administrator

  • Some people will install the vacuum booster line off the center carb. It will work but once again the location is not correct. This is where an OEM Brass T goes and that is a hard to find piece.

    • Some people will install the vacuum booster line off the cen…
    • Views: 739
    • By: Gallery Administrator

  • You will notice that the line and the linkage would function fine. It is once again just a matter of factual appearance.

    • You will notice that the line and the linkage would function…
    • Views: 652
    • By: Gallery Administrator

  • The front carb line should bend up and around that post on the top of the front carb. Now some may argue this point but I have taken many apart with this line and my 24,000 mile OEM GTO has that Original line installed as stated.

    • The front carb line should bend up and around that post on t…
    • Views: 824
    • By: Gallery Administrator