Gallery logo: Your photos on your web site

 

Album info

  • Title: Rexs 1970 Trans Am
  • Description: No description
  • Owner: Gallery Administrator

Random image

What a pain in the ass. I must admit I was thinking positive about finding all the items necessary to finalize this motor. Most are definately made of unobtainium. Here is a rare clutch fan

Rexs 1970 Trans Am

  • Chunks missing, large sections made out of Bondo. Cracks, Broken Hinge Bosses. What a work of art. How do people do this to these items. Well it is done. Looks great. I would put it on my car.

    • Chunks missing, large sections made out of Bondo. Cracks, B…
    • Views: 992
    • By: Gallery Administrator

  • The seal was quite a pain in the ass when I installed it. The 3M Weatherstrip Adhesive just would not stay where it was put. I would leak out on the edges and look yellow.

    • The seal was quite a pain in the ass when I installed it. T…
    • Views: 774
    • By: Gallery Administrator

  • There is just no room for a Chevy color on a T/A Shaker. Yellow belongs on No Go Chevy's. I just cannot have that color on a Pontiac. Had to switch to Bad Ass Black Sealent. Look at the nice selonoids.

    • There is just no room for a Chevy color on a T/A Shaker. Ye…
    • Views: 819
    • By: Gallery Administrator

  • All in all I took all the steps necessary to make sure that you will have a nice setup. It has been toleranced to operate correctly. The door opens fully, the selonoid rods are adjusted. The wiring is new. I shot the shaker with DP-90. then GM Sem...

    • All in all I took all the steps necessary to make sure that…
    • Views: 746
    • By: Gallery Administrator

  • The reason that I shoot it last with Rattle Can Paint is so that you can do a quick touch up before a car show. You can shoot it on and not worry about the paint reacting with the base paint. Feel free to touch it up any time. Not the Blue mind you ...

    • The reason that I shoot it last with Rattle Can Paint is so…
    • Views: 752
    • By: Gallery Administrator

  • Well in this case he gets lucky. Yes that is an OEM Switch. I also found the correct brackets for the carburetor and the switch. Talk about lucky.

    • Well in this case he gets lucky. Yes that is an OEM Switch.…
    • Views: 810
    • By: Gallery Administrator

  • Well here are the hard to find brackets. Not easy for me to let these go but here you go. Now your T/A is fully complete with a correctly functioning Shaker Air Inlet System.

    • Well here are the hard to find brackets. Not easy for me to…
    • Views: 752
    • By: Gallery Administrator

  • Let me know if you need the Bracket that goes on the Carburetor Throttle Base Plate also. I do not know if you have that in your stuff or not. Also I need to know if it snaps on a stud on the bracket or has a hole in it.

    • Let me know if you need the Bracket that goes on the Carbure…
    • Views: 826
    • By: Gallery Administrator

  • This little half moon tension clip is what holds the Switch in the hole in the bracket. The other two brackets bolt onto the top of the carburetor with a thru bolt to hold it to the intake.

    • This little half moon tension clip is what holds the Switch…
    • Views: 807
    • By: Gallery Administrator