Gallery logo: Your photos on your web site

Floyds Goat Motor

  • Do you see these little splines on the inside of the yoke? Well these are the only metal that mates to the Output Shaft. Yes all that Horsepower goes thru these little metal splines. Kinda makes you wonder how powerful your motor is.

    • Do you see these little splines on the inside of the yoke?…
    • Views: 717
    • By: Gallery Administrator

  • Now they also make Billet Transmission Yokes. They are better yet if the metal is correct and they are machined correctly. It is not only about looking perty. It is about being made correctly.

    • Now they also make Billet Transmission Yokes. They are bett…
    • Views: 810
    • By: Gallery Administrator

  • You can see that I coated the heck outa everything. I found that some of the tolerances were increased and I had to take some time to fit the parts.

    • You can see that I coated the heck outa everything. I found…
    • Views: 700
    • By: Gallery Administrator

  • Overall though the coating lived up to it's advertised claims that the overall dimensions were not significantly altered. I think in some cases they were increased about .001. I love tight fitting parts in the right places though.

    • Overall though the coating lived up to it's advertised…
    • Views: 724
    • By: Gallery Administrator

  • The White Metal parts are fresh out of the cleaner. They do not need coating and as such I only clean them to perfection. These parts are the Spacer Tube, Roller Bearings, Seperation Rings and Thrust Bushings.

    • The White Metal parts are fresh out of the cleaner. They do…
    • Views: 639
    • By: Gallery Administrator

  • Here you can see the Main Shaft. The Vasoline that I utilize in the installation of the Roller Bearings and the Spacer Bearings and etc. They all have to remain in place when you remove the Main Shaft.

    • Here you can see the Main Shaft. The Vasoline that I utiliz…
    • Views: 653
    • By: Gallery Administrator

  • Here they are. All American made components. Not coated and as produced. I have taken the time to clean all of these parts with evaporative cleaners. They are ready to go in.

    • Here they are. All American made components. Not coated an…
    • Views: 725
    • By: Gallery Administrator

  • Here you see the Roller Bearings all properly installed and inserted into the space between the Main Shaft and the Counter Gear.

    • Here you see the Roller Bearings all properly installed and…
    • Views: 880
    • By: Gallery Administrator

  • Once you are sure that every Bearing has been installed then the Spacer Ring is installed onto of the Race of Bearings. These will keep the Bearings from intermingling with the next group that ride on the Main Shaft.

    • Once you are sure that every Bearing has been installed then…
    • Views: 705
    • By: Gallery Administrator