Gallery logo: Your photos on your web site

 

Album info

  • Title: 350 HO
  • Description: This is another one of my Rockin and Stompin 350 High Output Engines. Check this one out because it has all the Bells and Whistles available for a 350 Pontiac.
  • Owner: Gallery Administrator

Random image

IM001292

350 HO

  • Only problem is that I can do it by hand in half the time. On top of that the hole is allways straight, properly threaded and down to the correct depth. Kinda makes me wonder!

    • Only problem is that I can do it by hand in half the time.…
    • Views: 699
    • By: Gallery Administrator

  • Since this is a Double Roller Chain Engine I do not have to worry about making them flush with the face of the block. I just have to get them into the block far enough to provide sealing and plug retention. There is plenty of room under the timing gear.

    • Since this is a Double Roller Chain Engine I do not have to…
    • Views: 808
    • By: Gallery Administrator

  • Besides I can just sit and laugh while I tell you of all the people who started to copy this update and threaded the holes to deep. Installed the plugs and blocked off the Oil Passages into the Crank.

    • Besides I can just sit and laugh while I tell you of all the…
    • Views: 705
    • By: Gallery Administrator

  • Ops my Custom Cam Bearing Installation Tool. Wonder how long it is going to take before the Camshaft People steal my idea and call it their own. Not only does this work for Babbit Bearings but it drives in Roller Bearings with Perfection.

    • Ops my Custom Cam Bearing Installation Tool. Wonder how lon…
    • Views: 844
    • By: Gallery Administrator

  • And then there is the Expanding Collet that accurately positions the Cam Shaft Bearing on the Drive Shaft Center Line. Does not Damage the inside Bearing Surface. Or install it cocked off center.

    • And then there is the Expanding Collet that accurately posit…
    • Views: 732
    • By: Gallery Administrator

  • The machining on this piece is also a GO, NO GO Guage. If it slides into the front of the block without some resistance, the Front Cam Shaft Bearing Bore is to large. If it does not go in to far then their is probably some Small Nicks, Burrs etc in t...

    • The machining on this piece is also a GO, NO GO Guage. If i…
    • Views: 893
    • By: Gallery Administrator

  • Well here is the correct Water Thremostat Housing for a 77 or 78 Pontiac Trans Am. Why would I want to utilize this. Just look at the finished pictures. Nice house routing. No abrasion against the hood. Better antifreeze flow.

    • Well here is the correct Water Thremostat Housing for a 77 o…
    • Views: 704
    • By: Gallery Administrator

  • You will also notice that Aluminum does not rust. I realize that the OEM Thermostat Housing was Aluminum but the Intake is Cast Iron, so should the Thermostat Housing. It will seal better and a whole lot of other good reasons abound.

    • You will also notice that Aluminum does not rust. I realize…
    • Views: 827
    • By: Gallery Administrator

  • These are the type of valves that I prefer. I have them Specially Manufactured for our business. They are from a Special Formulation of Steel. They are made to the correct dimensions to prevent damage to the engine due to valve failure.

    • These are the type of valves that I prefer. I have them Spe…
    • Views: 903
    • By: Gallery Administrator