Gallery logo: Your photos on your web site

 

Album info

  • Title: JIMS 66 389 YS
  • Description: No description
  • Owner: Gallery Administrator

Random image

Notice those OEM appearing leaf spring perches. They sure look nice and when bolted up the Pinion agle will be dead nuts on. That is the only way to do it. Right the first time.

JIMS 66 389 YS

  • Notice that the little arrows are no longer on the top of the pistons. That is because they were machined lighter to enable me to have a more favorable compression ratio.

    • Notice that the little arrows are no longer on the top of th…
    • Views: 646
    • By: Gallery Administrator

  • We also cut the decks one more time. I did the final cut to ensure that the gaskets were going to seal with perfection. Not to mention that the first cut was very minor.

    • We also cut the decks one more time. I did the final cut to…
    • Views: 593
    • By: Gallery Administrator

  • Once I button up an oiling system I always put on a filter to keep any garbage from getting into the galleys. It will not cost you any more time to ensure that the block is protected.

    • Once I button up an oiling system I always put on a filter t…
    • Views: 668
    • By: Gallery Administrator

  • I still prefer the Bronze Freeze Plugs. They are the best in my book and I really like the way they install. I have seen some gorillas bust in the side of a block installing the galvanized steel units. The block is actually fragile like a wine glass...

    • I still prefer the Bronze Freeze Plugs. They are the best i…
    • Views: 645
    • By: Gallery Administrator

  • In the process you will want to rotate the block to ensure that the windage tray does not hit the rods, crank and etc. Not to mention that you might have an unusual noise if you do not.

    • In the process you will want to rotate the block to ensure t…
    • Views: 641
    • By: Gallery Administrator

  • The oil pan pickup is specially ordered for the Milodon Oil Pan. It is required to function correctly with the oil pan. After all I want to get all the extra horsepower I can outa the pan.

    • The oil pan pickup is specially ordered for the Milodon Oil…
    • Views: 751
    • By: Gallery Administrator

  • Notice that there is a retention bolt that secures the pickup to the oil pump housing. It has to be torqued into place and also sealed into the housing pickup bore. No hints about this.

    • Notice that there is a retention bolt that secures the picku…
    • Views: 625
    • By: Gallery Administrator

  • Once again make sure you put the little extra oil dipstick tube extension into the windage tray. It fits there in the spot that it should. Sometimes they need a little fitting to seat right.

    • Once again make sure you put the little extra oil dipstick t…
    • Views: 617
    • By: Gallery Administrator

  • I have taken the time to fit the Stainless Steel Water Pump Dividers into the Timing Cover proper. You might not realize it but these items just do not drop into the cover.

    • I have taken the time to fit the Stainless Steel Water Pump…
    • Views: 566
    • By: Gallery Administrator