Gallery logo: Your photos on your web site

 

Album info

  • Title: Kirks Judge Motor
  • Description: No description
  • Owner: Gallery Administrator

Random image

MX7R7587

Kirks Judge Motor

  • At the same time I also like a bronze bushing and full floating piston pins. Now many people will argue this point but take the time to conside this fact. The piston is Aluminum and it does not wear. Will the bronze?

    • At the same time I also like a bronze bushing and full float…
    • Views: 706
    • By: Gallery Administrator

  • These of course are our best line of defense against engine failure. I promote this line of rods for our Street Strip engines and also rare engine block packages. If you have the finances to build a Ram Air motor then you can afford this degree of pr...

    • These of course are our best line of defense against engine…
    • Views: 721
    • By: Gallery Administrator

  • In this case Kirk agreed and I can now sleep at night. There is one line of Connecting Rod that we offer that is actually far better than these but they cost Thousands of Dollars and they are primarilly designed for Strip utilization. Not street.

    • In this case Kirk agreed and I can now sleep at night. Ther…
    • Views: 953
    • By: Gallery Administrator

  • This would be my choice. I would much rather prefer to install a nice set of Stainless Steel H Beam Connecting Rods. Not many people know the difference between the I Beam design and the H Beam design. These will be the best choice for his street mo...

    • This would be my choice. I would much rather prefer to inst…
    • Views: 834
    • By: Gallery Administrator

  • Here are the actual pistons that I am going to use during the assembly of your motor. You will notice that they are forged units. That is the only set to go with. Sure read all you want. Talk to all the people you want. Feeling lucky? I know what...

    • Here are the actual pistons that I am going to use during th…
    • Views: 714
    • By: Gallery Administrator

  • But I do have a High Temperature Coating that keeps them looking like they were brand new installed from the factory. That is the way they should look anyway. They will stay that way as long as you do not scratch them during install

    • But I do have a High Temperature Coating that keeps them loo…
    • Views: 886
    • By: Gallery Administrator

  • One of the ways to reduce that compression is the four valve reliefs. The other way is the machining I perform around the outside of the piston. Ups don't tell anyone. Then they will know the secret.

    • One of the ways to reduce that compression is the four valve…
    • Views: 757
    • By: Gallery Administrator

  • This will give you liveable compression on pump gas. It will enable you to have your Ram Air Three Heads and still run with the big dogs. Kinda neat.

    • This will give you liveable compression on pump gas. It wil…
    • Views: 784
    • By: Gallery Administrator

  • I clean them off and make sure that the piston pins are fully pin fitted to each piston. Not many people will even bother to check the piston pin to the piston pin bore clearance. One machinist once asked me how to do it.

    • I clean them off and make sure that the piston pins are full…
    • Views: 650
    • By: Gallery Administrator