Gallery logo: Your photos on your web site

 

Album info

  • Title: Kirks Judge Motor
  • Description: No description
  • Owner: Gallery Administrator

Random image

He was instructed to take it all apart. Tap all the threaded holes, remove any spec of anything, lightly radius the edges of the drive and driven gears, remove the cast iron flashing and parting lines.

Kirks Judge Motor

  • Once you have the bearings and studs installed the bearings are lubed with our special anti wear lube and the crankshaft is set down carefully into the bearings.

    • Once you have the bearings and studs installed the bearings…
    • Views: 840
    • By: Gallery Administrator

  • It is also critical that the oil dipstick tube is installed first. Once the number three main cap is in place you will have quite a hard time installing it.

    • It is also critical that the oil dipstick tube is installed…
    • Views: 692
    • By: Gallery Administrator

  • The studs are correctly torqued. The special ARP lube is applied to the nuts and the washers. You also should put the lube on the threads. There is no way to check stretch with these studs.

    • The studs are correctly torqued. The special ARP lube is ap…
    • Views: 735
    • By: Gallery Administrator

  • It is also very important to hand fit the caps to the block. They have to bolt down square to the block to function right. In the case of this block the actual factory holes were out of alignment.

    • It is also very important to hand fit the caps to the block.…
    • Views: 690
    • By: Gallery Administrator

  • Here you can see the Top of the Line Sealed Power Forged Pistons. I really like these and they are my pick for a Heavy Street or Strip motor.

    • Here you can see the Top of the Line Sealed Power Forged Pis…
    • Views: 817
    • By: Gallery Administrator

  • These rods are the best that we manufacture. In this case they are just good insurance against connecting rod failure. I will not build a motor without our rods installed.

    • These rods are the best that we manufacture. In this case t…
    • Views: 765
    • By: Gallery Administrator

  • These rods also have ARP Rod Bolts installed. We will actually stretch these bolts to .0063. Then I will know beyond a doubt that they are correctly torqued.

    • These rods also have ARP Rod Bolts installed. We will actua…
    • Views: 836
    • By: Gallery Administrator

  • All of the factory holes need to be tapped to ensure that the fasteners are correctly seating into the block. Not to mention that without a clean bore the torque reading will not be correct.

    • All of the factory holes need to be tapped to ensure that th…
    • Views: 866
    • By: Gallery Administrator

  • It is also imperative that every single little space in the block is free of all metal, grit, grime and everything else. You need to be extremely careful at this stage of assembly

    • It is also imperative that every single little space in the…
    • Views: 872
    • By: Gallery Administrator