Gallery logo: Your photos on your web site

 

Album info

  • Title: Kirks Judge Motor
  • Description: No description
  • Owner: Gallery Administrator

Random image

IM004528

Kirks Judge Motor

  • When it comes to the front timing cover they are manufactured out of aluminum. It is very easy to cross thread the bolts into the timing cover and destroy the threads.

    • When it comes to the front timing cover they are manufacture…
    • Views: 830
    • By: Gallery Administrator

  • The bores have to be absolutely clean. I take the time to make sure that there are no witness marks in the bores around the area that the rings come together.

    • The bores have to be absolutely clean. I take the time to m…
    • Views: 761
    • By: Gallery Administrator

  • Once I rotate the crank over several times and do not see any type of mark or scratch in the bores will I bolt on heads. I must admit I have now become very critical on the ring inspection and installation.

    • Once I rotate the crank over several times and do not see an…
    • Views: 774
    • By: Gallery Administrator

  • Here are the new pushrods, ARP Head Bolts and the Comp Cams Roller Tip Rocker Arms that I will be utilizing in this build. It is top notch all the way around. We also utilized Comp Cams Double Roller Timing Chain.

    • Here are the new pushrods, ARP Head Bolts and the Comp Cams…
    • Views: 667
    • By: Gallery Administrator

  • Just take a gander at that beautiful surfacing job on the heads. Our Stainless Steel Valves just look ready to go. They ought to keep the compression up because they are flat and not tuliped.

    • Just take a gander at that beautiful surfacing job on the he…
    • Views: 622
    • By: Gallery Administrator

  • I had to also machine the exhaust flanges flat. You can see the little witness mark on the center married exhaust ports. They would of leaked and that would be no good.

    • I had to also machine the exhaust flanges flat. You can see…
    • Views: 817
    • By: Gallery Administrator

  • Sometimes you have to machine the intake manifold flanges to mate up the head deck machining. In this case I just removed enough to clean up the surfaces and did not cut the heck outa them. So I do not need to surface the intake flanges.

    • Sometimes you have to machine the intake manifold flanges to…
    • Views: 703
    • By: Gallery Administrator

  • I dropped the ball. I should of shot more pics of the assembly process, but here it is. Almost done. Now the hard part of finding all the little items that make it correct.

    • I dropped the ball. I should of shot more pics of the assem…
    • Views: 595
    • By: Gallery Administrator

  • I need to get alot of items just to dyno it. Oil Pressure Sending Units, Water Temp Sending Units, Lower Harmonic Balancer Pulley, Correct Alternator Bracket, Exhaust Manifold Heat Shield, Carb Throttle Arm, Accelerator Bracket, Choke Thermostat.

    • I need to get alot of items just to dyno it. Oil Pressure S…
    • Views: 813
    • By: Gallery Administrator