Gallery logo: Your photos on your web site

 

Album info

  • Title: Marcos 66 GTO 389
  • Description: No description
  • Owner: Gallery Administrator

Random image

Baby Got Back

Marcos 66 GTO 389

  • I was going to sell you a tranny off the shelf but I do not have any more left. So now I got to find one that is correct and build it for you. Oh well, that way I will know it is fresh and ready to rock and roll.

    • I was going to sell you a tranny off the shelf but I do not…
    • Views: 783
    • By: Gallery Administrator

  • Some people will utilize substandard cases in the assembly of a tranny. Not me, if it is not up to my standards then it becomes a bird house.

    • Some people will utilize substandard cases in the assembly o…
    • Views: 813
    • By: Gallery Administrator

  • Here is a pic of all the items that will have to go into your tranny. Lots of inspected and remanufactured used items and lots of new replacement items.

    • Here is a pic of all the items that will have to go into you…
    • Views: 761
    • By: Gallery Administrator

  • Usually the only items that are remanufactured are the Case, Bearing Support, Tailshaft Housing, Main Drive Shaft, Counter Gear, Forward Bearing Retainer and some of the gears.

    • Usually the only items that are remanufactured are the Case,…
    • Views: 775
    • By: Gallery Administrator

  • Of course that is all open for discussion when I get the core to rebuild. They are usually pretty well worn out now. Only about 45 years is the time for them to stay nice.

    • Of course that is all open for discussion when I get the cor…
    • Views: 754
    • By: Gallery Administrator

  • The Main Shaft is seldom worn. The Americans really used the top quality metal to make this tire checker. I have only seen one that was ever bad and it was due to a moron who did not add tranny fluid upon startup.

    • The Main Shaft is seldom worn. The Americans really used the…
    • Views: 849
    • By: Gallery Administrator

  • Now in the assembly of the Main Counter Shaft Assembly I will utilize new Blocker Rings, Strut Type Collars, Hubs, Shift Keys, Springs, C Clips, Case Bearings, Input Shaft Bearings and Counter Gear Bearings.

    • Now in the assembly of the Main Counter Shaft Assembly I wil…
    • Views: 807
    • By: Gallery Administrator

  • Once assembled into the correct locations I will install it into the case with the Main Case Bearing Retainer holding the whole assembly into the case.

    • Once assembled into the correct locations I will install it…
    • Views: 654
    • By: Gallery Administrator

  • Then the whole assembly will look just like this. All fitting into a nice and tight Munice M-20 Aluminum Case. You will find that they will shift a bit hard at first until they wear in. Once they get a little worn they will slide like butter on a ho...

    • Then the whole assembly will look just like this. All fitti…
    • Views: 735
    • By: Gallery Administrator