Gallery logo: Your photos on your web site

 

Album info

  • Title: Robs Camaro
  • Description: Oh shit, did I forget to tell you guys I used to be Camaro Dan? Well it is true. I used to be Mopar Dan before that then there was a brief stint as MG Dan. Go figure. Well all my buddies just own different cars. The DZ 302 and this car are but a few of the total done by me.
  • Owner: Gallery Administrator

Random image

Center Carburetor Bowl Vent and Leaded Passageways

Robs Camaro

  • I used "Cast Blast" It is a paint that simulates the appearance of a cast iron part. It works great and as such also looks as am OEM appearing part.

    • I used "Cast Blast" It is a paint that simulates…
    • Views: 905
    • By: Gallery Administrator

  • There are many manufacturers of this paint. Feel free to try them all. Remember these are primarilly needed to stop rusting and corrosion. I do not paint the part to make it purty.

    • There are many manufacturers of this paint. Feel free to tr…
    • Views: 792
    • By: Gallery Administrator

  • Here is a picture of the overall parts necessary to do the job right. As you can see there are many parts inside a "DIFF"

    • Here is a picture of the overall parts necessary to do the j…
    • Views: 791
    • By: Gallery Administrator

  • I have cleaned this housing three times until the cleaning fluid comes out clean the job is not done. Remember these bearings are just as tight as your engine bearings. Little pieces of sand or metal will destroy this diff quick.

    • I have cleaned this housing three times until the cleaning f…
    • Views: 840
    • By: Gallery Administrator

  • Here is the shot of the Pinion Bore and the Bearing Races. These races are installed by being cooled. Once Frozen the Races just drop in. You have to be careful not to touch the metal because the liquid Nitrogen freezes the metal quite colder than i...

    • Here is the shot of the Pinion Bore and the Bearing Races.…
    • Views: 887
    • By: Gallery Administrator

  • Oh darn how did this top secret most important little modification ever get photographed. What ever you do please do not tell the other Diff shops how to make these Ten Bolt Diffs better. They might get some customers.

    • Oh darn how did this top secret most important little modifi…
    • Views: 772
    • By: Gallery Administrator

  • Of course I custom machined this little part to the pre required dimension of this particular gearset. Just in case my "Mental Math" was not accurate I also have Selective Thickness Shims to tolerance it up perfect. Nice to eliminate the biggest "Fai...

    • Of course I custom machined this little part to the pre requ…
    • Views: 818
    • By: Gallery Administrator

  • Here we go checking the Pinion location from the top of the pinion to the center of the ring gear. My setup is accurate to within .001. Of course his measurement was 2.534 inches.

    • Here we go checking the Pinion location from the top of the…
    • Views: 857
    • By: Gallery Administrator

  • Once done with the measurement I check for "Stack Error" and divide the difference to set it up dead nuts.

    • Once done with the measurement I check for "Stack Error…
    • Views: 873
    • By: Gallery Administrator