Gallery logo: Your photos on your web site

 

Album info

  • Title: Kevins 67 Goat
  • Description: No description
  • Owner: Gallery Administrator

Random image

Can you see those little holes in the heads. Those are the pushrod guide plates per see. In this case if they are not in the correct location the rocker arm does not sit right on the valve.

Kevins 67 Goat

  • Here is your actual clutch disk. It is pretty much the same as any other clutch disk. Do not drop it. Do not pry things apart with it. I looks real neat and strong but in all actuality it is quite fragile. If you bend it you will know it.

    • Here is your actual clutch disk. It is pretty much the same…
    • Views: 855
    • By: Gallery Administrator

  • The ten pucks that are bonded to the copper rings are made of metal and composite material. They will last far longer than any other type of clutch material. They will also make your car go sideways on command.

    • The ten pucks that are bonded to the copper rings are made o…
    • Views: 788
    • By: Gallery Administrator

  • Notice the Heavy Duty Springs in the inner hub. These will help the disk engage with a nice easy motion. That will keep your coffee in your cup. Be nice to this disk. I will give you all the instructions that you need to install it.

    • Notice the Heavy Duty Springs in the inner hub. These will…
    • Views: 683
    • By: Gallery Administrator

  • In the long run you will be happy that you went this way. They are a real nice setup. Best of both worlds. You will not have to change your clutch disk all the time and you will have more fun driving your car.

    • In the long run you will be happy that you went this way. T…
    • Views: 558
    • By: Gallery Administrator

  • I will have to keep this pressure plate for the engine build. This is the actual plate that I will be using. I have numbered it for your engine assembly. I have also balanced it for your motor. Notice the weight that I welded onto the hat to make i...

    • I will have to keep this pressure plate for the engine build…
    • Views: 603
    • By: Gallery Administrator

  • All the parts in the Pressure Plate are new. I have taken the time to set it up for a Performance Clutch Disk. It will have a bit more release pressure needed but should not make your leg build more muscles than the other one.

    • All the parts in the Pressure Plate are new. I have taken t…
    • Views: 724
    • By: Gallery Administrator

  • Here is the Bellhousing that I have picked for your car. It is the correct Pontiac Bellhousing. I have Thermal Cleaned it and then Media Blasted it. It is ready for installation.

    • Here is the Bellhousing that I have picked for your car. It…
    • Views: 625
    • By: Gallery Administrator

  • When I load all the parts into the crate I will include the Bellhousing Shift Fork Pivot Ball. It will be installed into the Bellhousing like it is now. I will include the Shift Fork Seal, Lower Inspection Cover.

    • When I load all the parts into the crate I will include the…
    • Views: 766
    • By: Gallery Administrator

  • Shift Fork Adjustment Rod, Z Bar, Clutch Pedal Firewall Push Rod, Firewall Seal, Shifter, Shift Rods, Shift Dogs, Hopefully as much of the Four Speed Stuff as I can cramm into the crate and not overfill it.

    • Shift Fork Adjustment Rod, Z Bar, Clutch Pedal Firewall Push…
    • Views: 677
    • By: Gallery Administrator