Gallery logo: Your photos on your web site

 

Album info

  • Title: Bills 389 Tri Power
  • Description: No description
  • Owner: Gallery Administrator

Random image

IMAG2136

Bills 389 Tri Power

  • In that case it's all junk. Time to start over. You will notice the correct guage for checking Rod Bolt Stretch. .0063. Yes that is the correct stretch for the rod bolt. Only one time to get it and if you go over the bolt is ruined.

    • In that case it's all junk. Time to start over. You w…
    • Views: 759
    • By: Gallery Administrator

  • Now here is the OEM distributor. I take pride and care when we rebuild the point type distributor. In most cases it goes electronic anyway.

    • Now here is the OEM distributor. I take pride and care when…
    • Views: 766
    • By: Gallery Administrator

  • Yes just look at the points, condensor, and wiring. It will all be gone shortly. I will be converting it to Digital Electronic with Rev Limiter Operation.

    • Yes just look at the points, condensor, and wiring. It will…
    • Views: 968
    • By: Gallery Administrator

  • But why you ask? Well these tri power engines do not have enough room behind that fat manifold to fit an HEI. So here you take this little gem and drop it in.

    • But why you ask? Well these tri power engines do not have e…
    • Views: 787
    • By: Gallery Administrator

  • All these nice and new components are going to go on an OEM points Distributor for another car.

    • All these nice and new components are going to go on an OEM…
    • Views: 837
    • By: Gallery Administrator

  • These are the items necessary to install onto our State of the Art GTO. I like this kit and love installing it. Easy and simple to do.

    • These are the items necessary to install onto our State of t…
    • Views: 764
    • By: Gallery Administrator

  • First unscrew all the items on the points plate. I leave the ground wire attached to the distributor case. I is not in the way and supplies ground. Add Silicone Diaelectric grease for the heat transfer.

    • First unscrew all the items on the points plate. I leave th…
    • Views: 846
    • By: Gallery Administrator

  • Save the OEM Groumet off the Points wire. It will look good over the new wires that will come out here.

    • Save the OEM Groumet off the Points wire. It will look good…
    • Views: 945
    • By: Gallery Administrator

  • Install the module. Finger tighten the screws down. Then apply pressure and push the module up as close to the points block as possible and bolt it down. That is it. Make sure it does not hit though.

    • Install the module. Finger tighten the screws down. Then a…
    • Views: 824
    • By: Gallery Administrator