Gallery logo: Your photos on your web site

 

Album info

  • Title: Bills 389 Tri Power
  • Description: No description
  • Owner: Gallery Administrator

Random image

I wish I had time to shoot all the pics of the complete disassembly and reassembly of the transmission. In all actuality I shot quite a bit more than I have listed but it all take time and effort to resize, crop and etc them.

Bills 389 Tri Power

  • There are several sets out there and they do not fit for anything. You see the bottom three stud flange has the studs incorrectly clocked to the chassis. One of the bolts will hit the lower control arm mounting boss.

    • There are several sets out there and they do not fit for any…
    • Views: 897
    • By: Gallery Administrator

  • You must admit this was my choice. These Stock Ram Air Exhaust Manifolds are the hit. They do not leak once properly installed. They are not speed bump magnets. They also flow really darn well.

    • You must admit this was my choice. These Stock Ram Air Exha…
    • Views: 854
    • By: Gallery Administrator

  • Here is a picture of the Brighter Coating. This is not for the Faint of Wallet. This coating process is a pain in the ass. They have to be abrasively cleaned both inside and out. That way they will take coating inside of the manifold and on the out...

    • Here is a picture of the Brighter Coating. This is not for…
    • Views: 885
    • By: Gallery Administrator

  • This will keep the heat inside the manifolds and also limit the exposure of the underhood environment to excessive thermal radiation. That excessive heat will cook your wires, overheat the incoming air and fuel mixture and make your engine run slower.

    • This will keep the heat inside the manifolds and also limit…
    • Views: 1056
    • By: Gallery Administrator

  • Not to mention cook your Starter and Selonoid. Every see some poor bloke stuck in rush hour traffic with an over heated engine and the starter not turning over. Now you know.

    • Not to mention cook your Starter and Selonoid. Every see so…
    • Views: 826
    • By: Gallery Administrator

  • Yes I even coat the manifold flanges. You see it all should look good. Not just the manifolds.

    • Yes I even coat the manifold flanges. You see it all should…
    • Views: 962
    • By: Gallery Administrator

  • Well this coating can solve that and a whole lot of other problems. I just happen to like it because it looks good and does not burn off. Of course if you scratch it then it's all over.

    • Well this coating can solve that and a whole lot of other pr…
    • Views: 757
    • By: Gallery Administrator

  • The manifold will rust in the scratched area and the finish is soon to be gone. Unfortunate but true. You will have to take care of these with Kit Gloves.

    • The manifold will rust in the scratched area and the finish…
    • Views: 954
    • By: Gallery Administrator

  • Unfortunately you will not find any Aftermarket set with the Exhaust flapper valve installed and functional. They have to be installed by hand and are nothing short of very difficult.

    • Unfortunately you will not find any Aftermarket set with the…
    • Views: 1033
    • By: Gallery Administrator