Gallery logo: Your photos on your web site

 

Album info

  • Title: JIMS 66 389 YS
  • Description: No description
  • Owner: Gallery Administrator

Random image

You can see even the Big Guys made mistakes. But sooner or later someone came along and slapped them alongside the head and they changed the way the ball rolled

JIMS 66 389 YS

  • On top of that it is the only one I have done to this level of perfection. Every single spec from the pinion bearing preload, side gear tolerance, clutch stack tolerance, disk brake rotor runout, and overall design improvement is perfect.

    • On top of that it is the only one I have done to this level…
    • Views: 705
    • By: Gallery Administrator

  • About the only thing I would of done to improve it beyond this step would of been to gun drill the axles. In the process I would of threaded a fill plug into each axle flange. Then you could fill the oil on the diff without crawling under your car. ...

    • About the only thing I would of done to improve it beyond th…
    • Views: 648
    • By: Gallery Administrator

  • This is to be the best aligning intake manifold that the motor will love. You see the ports really need to be in alignment. That is the cure to a Swiss Watch Motor.

    • This is to be the best aligning intake manifold that the mot…
    • Views: 698
    • By: Gallery Administrator

  • If you take a look at the ports you can see the port misalignment. There is quite a bit of extra metal that has to be removed. This is just the way it is. If you want it right the extra metal has to go.

    • If you take a look at the ports you can see the port misalig…
    • Views: 808
    • By: Gallery Administrator

  • In this case you can see that the overhang by the intake manifold is quite obvious. About .125 of an inch intrusion into the intake port.

    • In this case you can see that the overhang by the intake man…
    • Views: 768
    • By: Gallery Administrator

  • I am going to get the floor and the side walls ported to match the heads. It will take some judicious grinding and blending into the walls of the intake manifold.

    • I am going to get the floor and the side walls ported to mat…
    • Views: 837
    • By: Gallery Administrator

  • Look ma, no hands. I just love to see a nice Pontiac Manifold hanging off my bench in space. You see when they are happy about being operated upon they will stand up on one flange all by themselves.

    • Look ma, no hands. I just love to see a nice Pontiac Manifo…
    • Views: 861
    • By: Gallery Administrator

  • Now, that I got it's attention I can start the grinding process. It takes a big air compressor and a whole lot of air tools and carbide bits to perform this task.

    • Now, that I got it's attention I can start the grinding…
    • Views: 747
    • By: Gallery Administrator

  • Remember the bits have to have a 4 to 6 inch long shank to fit all the way into the intake manifold. This is the only way to make sure that the blend is all the way into the manifold.

    • Remember the bits have to have a 4 to 6 inch long shank to f…
    • Views: 688
    • By: Gallery Administrator