Gallery logo: Your photos on your web site

 

Album info

  • Title: JIMS 66 389 YS
  • Description: No description
  • Owner: Gallery Administrator

Random image

You can see the complete firewall. I know that you probally think this car is salvageable and you are right. I can fix it. I will fix it. But why not use two cars in the process and combine the best of both vehicles while saving the customer money?

JIMS 66 389 YS

  • I must admit I have grown tired of taking nice Camera pics in the Machine Shop. I am afraid of filling my perty camera full of grease. Or perhaps forgetting to remove it.

    • I must admit I have grown tired of taking nice Camera pics i…
    • Views: 1017
    • By: Gallery Administrator

  • You can see the specialized coatings on the side skirts of the pistons. You will notice that they are pretty much the same old pistons, just nice coatings.

    • You can see the specialized coatings on the side skirts of t…
    • Views: 830
    • By: Gallery Administrator

  • Do you like my neat rod holders. All you need is some 3/8 inch round stock and a big pair of pliers. You can make all you want now. Just get to work bending.

    • Do you like my neat rod holders. All you need is some 3/8 i…
    • Views: 704
    • By: Gallery Administrator

  • I like the neat Sealed Power Emblem that is in the middle of the piston skirts. Well I wonder how that helps out.

    • I like the neat Sealed Power Emblem that is in the middle of…
    • Views: 927
    • By: Gallery Administrator

  • Here is a better shot of the tops of the pistons. You will notice that the metal where I removed some metal is nice and shiny. Just a little shave here or there to lower compression.

    • Here is a better shot of the tops of the pistons. You will…
    • Views: 830
    • By: Gallery Administrator

  • Notice the neat coating that is applied to the side of the pistons. That will keep them from skuffing the bores during the installation. I never had any problems with the old design.

    • Notice the neat coating that is applied to the side of the p…
    • Views: 813
    • By: Gallery Administrator

  • Here are all the neat items that your High Tech Machine shop needs. I Snap On pry bar. A nice custom engineered connecting rod carrying device. A solid metal table top. and a good machinist.

    • Here are all the neat items that your High Tech Machine shop…
    • Views: 692
    • By: Gallery Administrator

  • I have just finished the piston installation process. Many people just do not understand the time and accuracy that is required when installing pistons. I install the crank to determine the pin location before I install the pistons.

    • I have just finished the piston installation process. Many…
    • Views: 614
    • By: Gallery Administrator

  • I needed to mock up the actual crankshaft to spec the valve relief locations to the top piston ring lands. In all cases I check my work. I was dead on as usual. Notice all the drilled holes I put in his crankshaft in balancing it

    • I needed to mock up the actual crankshaft to spec the valve…
    • Views: 613
    • By: Gallery Administrator