Gallery logo: Your photos on your web site

 

Album info

  • Title: JIMS 66 389 YS
  • Description: No description
  • Owner: Gallery Administrator

Random image

Here is the picture of the Power Steering Housing that he knocked the dents out of. You see you can save old tin if you just take your time with a careful hammer.

JIMS 66 389 YS

  • Areas that require some additional welds should be considered from a welders point of view. Now many people think that they can go down to their local welders supply and get all they need.

    • Areas that require some additional welds should be considere…
    • Views: 767
    • By: Gallery Administrator

  • Not is the case. You need an Ocean going Vessel welder to do this job right. Now sure you can make it look nice and perty, but it will not be structural.

    • Not is the case. You need an Ocean going Vessel welder to d…
    • Views: 833
    • By: Gallery Administrator

  • There are some areas that are best left to collapse during an impact. As far as I am concerned I do not want to have the whole front of my car in my lap. Not to mention that the front of the frame hits the bumps first.

    • There are some areas that are best left to collapse during a…
    • Views: 796
    • By: Gallery Administrator

  • In the rear of the car it is best just to weld up the seam that has been welded from the factory. If you are hit hard enough to bend this frame then you probably will be bent also.

    • In the rear of the car it is best just to weld up the seam t…
    • Views: 658
    • By: Gallery Administrator

  • Where ever you add Polyurethane Bushings or Boxed Control Arms you can expect that they will also need reinforced areas and welds to keep all that extra force confined.

    • Where ever you add Polyurethane Bushings or Boxed Control Ar…
    • Views: 845
    • By: Gallery Administrator

  • In this case, it is best to reinforce these areas. It is really hard to weld this up when the car is ontop of the frame. Do not forget that the frame is under the car in this area and does not require a whole lot of grinding.

    • In this case, it is best to reinforce these areas. It is re…
    • Views: 698
    • By: Gallery Administrator

  • Here is the other Lower Control Arm Attaching Point. This little area will take a whole lot more shock load with Polyurethane Bushings. They do not flex like the old rott to hell rubber bushings did.

    • Here is the other Lower Control Arm Attaching Point. This l…
    • Views: 760
    • By: Gallery Administrator

  • In this process you also have to ensure that the correct areas are welded up ocean going vessel style. Some of the other cosmetic areas can be welded up by the beginners.

    • In this process you also have to ensure that the correct are…
    • Views: 820
    • By: Gallery Administrator

  • In this case Jim helped out as best he could with a little 110 volt buzz box. Lots of the welds were serviceable. When I was welding in the boxed plates I was happy thru half of the process.

    • In this case Jim helped out as best he could with a little 1…
    • Views: 863
    • By: Gallery Administrator