Gallery logo: Your photos on your web site

 

Album info

  • Title: JIMS 66 389 YS
  • Description: No description
  • Owner: Gallery Administrator

Random image

This Yellow is definately Yellow. You can just see this ontop of that Big Block Bumble Bee Chevy. Now don't get mad, the chevy's look ok.

JIMS 66 389 YS

  • Notice that the Disk Brake Rotor and the fact that the Caliper is not on the differential. There are other items that are missing and this can be a problem. I will have to take a trip down to the dealer.

    • Notice that the Disk Brake Rotor and the fact that the Calip…
    • Views: 692
    • By: Gallery Administrator

  • Here is what you look for. Twelve bolts parallel to the ground. That is the only way to tell a 12 bolt diff once it is in the vehicle. I cannot wait to see what gears are inside this diff.

    • Here is what you look for. Twelve bolts parallel to the gro…
    • Views: 641
    • By: Gallery Administrator

  • Butt Ugly. That is how they all look like once I start to perform the Differential Face Lifts. When it leaves it will look OEM NOS Perfect. You just wait.

    • Butt Ugly. That is how they all look like once I start to p…
    • Views: 616
    • By: Gallery Administrator

  • The tubes are always a bit off. You have to straighten them if you are serious about building a good diff. You see if the holes on both tubes where the axle bearings go are off then the bearings wear out quick.

    • The tubes are always a bit off. You have to straighten them…
    • Views: 697
    • By: Gallery Administrator

  • Notice the rust beginning to form. This happens litterely the minute you get it out of the blast booth. You can only solve this problem by shake and baking the center section. That is hard to do and not warp the axle tubes.

    • Notice the rust beginning to form. This happens litterely t…
    • Views: 679
    • By: Gallery Administrator

  • Jim did a fine job of Garnet Media Blasting the housing. It was really clean. I had to blast it all over again before coating it though. I need the metal to be as close to near white as possible. I like for my coatings to adhere perfectly.

    • Jim did a fine job of Garnet Media Blasting the housing. It…
    • Views: 696
    • By: Gallery Administrator

  • Most of the items necessary to install the carrier and pinion are here on the table. I am going to improve upon this design by making it the Super Diff it should be.

    • Most of the items necessary to install the carrier and pinio…
    • Views: 868
    • By: Gallery Administrator

  • Here is the completed, Garnet Media Blasted, Coated and Straightened Housing. Now I am ready to assemble. What a hoot that is going to be. The differential is going to be a real pain in the ass.

    • Here is the completed, Garnet Media Blasted, Coated and Stra…
    • Views: 692
    • By: Gallery Administrator

  • This work was done so that I could create the best 12 bolt differential for a 66 GTO to date.You see with these big diameter bearings on the outboard side it is like OEM C-Clip Eliminators.

    • This work was done so that I could create the best 12 bolt d…
    • Views: 718
    • By: Gallery Administrator